LT6411

LT6411650MHz的差分ADC驱动器/双可选增益放大器特点

应用

• Differential ADC Driver差分ADC驱动器
• Single-Ended to Differential Conversion单端至差分转换
• Differential Video Line Driver差分视频线驱动器

• 650MHz –3dB Small-Signal Bandwidth 650MHz的-3dB的小信号带宽
• 600MHz –3dB Large-Signal Bandwidth 600MHz的-3dB的大信号带宽
• High Slew Rate: 3300V/µs 高压摆率：3300V/μs
• Easily Configured for Single-Ended to Differential Conversion 轻松配置为单端至差分转换
• 200MHz ±0.1dB Bandwidth为200MHz±0.1dB带宽
• User Selectable Gain of +1, +2 and –1用户可选择增益+1，+2，-1
• No External Resistors Required无需外部电阻
• 46.5dBm Equivalent OIP3 at 30MHz When Driving an ADC当驱动ADC在30MHz等效46.5dBm的OIP3
• IM3 with 2VP-P Composite, Differential Output:互调与差分输出2VP-P复合：
  –87dBc at 30MHz, –83dBc at 70MHz在70MHz时-87dBc，-83dBc在30MHz
• –77dB SFDR at 30MHz, 2VP-P Differential Output 77分贝的SFDR在30MHz，2VP-P的差分输出
• 6ns 0.1% Settling Time for 2V Step为6ns 0.1％，稳定时间为2V步骤
• Low Supply Current: 8mA per Ampifier低电源电流：每Ampifier的8毫安
• Differential Gain of 0.02%, Differential Phase of 0.01° 0.02％的差分增益，差分相0.01°
• 50dB Channel Separation at 100MHz在100MHz50分贝通道分离
• Wide Supply Range: ±2.25V (4.5V) to ±6.3V (12.6V)宽电源电压范围：±2.25V（4.5V）到±6.3V（12.6V）
• 3mm × 3mm 16-Pin QFN Package采用3mm x 3mm 16引脚QFN封装
• 描述 The LT6411 is a dual amplifier with individually selectable gains of +1, +2 and –1. LT6411是一个单独可选增益+1，+2，-1双放大器。 The amplifiers have excellent distortion performance for driving ADCs as well as excellent bandwidth and slew rate for video, data transmission and other high speed applications.放大器具有优良的失真性能，用于驱动ADC以及出色的带宽，视频，数据传输等高速应用和转换率。 Single-ended to differential conversion with a system gain of 2 is particularly straightforward by configuring one amplifier with a gain of +1 and the other amplifier with a gain of –1.系统增益为2的单端至差分转换，特别是直接配置一个放大器增益为+1和其他放大器增益-1。 The LT6411 can be used on split supplies as large as ±6V and on a single supply as low as 4.5V.的LT6411可用于分离电源为±6V大作为低如4.5V的单电源。 Each amplifier draws only 8mA of quiescent current when enabled.启用时，每个放大器仅消耗静态电流8毫安的。 When disabled, the output pins become high impedance and each amplifier draws less than 350µA.禁用时，输出引脚变为高阻抗，每个放大器的投篮比350μA以下。 The LT6411 is manufactured on Linear Technology's proprietary, low voltage, complimentary, bipolar process and is available in the ultra-compact, 3mm × 3mm, 16pin QFN package. LT6411是凌力尔特公司专有的，低电压，免费，双极工艺和制造，是在超小型的3mm×3mm的，16PIN的QFN封装
•