EL2141

• Fully differential inputs, outputs, and feedback全差分输入，输出和反馈
• Differential input range ±2.3V差分输入范围± 2.3V的
• 150MHz 3dB bandwidth 150MHz的3dB带宽
• 800V/µs slew rate 800V/μs转换率
• -55dB distortion at 3MHz - 3MHz的为55dB失真
• -75dB distortion at 100kHz -七十五分贝在100kHz失真
• ±5V supplies or +6V single supply ± 5V电源或+6 V单电源
• 50mA minimum output current 50mA的最小输出电流
• Output swing (200Ω load) to within 1.5V of supplies (14VPKPK differential)输出摆幅（200Ω负载）的供应1.5V的范围内（14VPKPK差分）
• Low power-11mA typical supply current低功耗电源电流为11mA典型
• Pb-free available (RoHS compliant)无铅可用（符合RoHS）

The EL2141 is a very high bandwidth amplifier whose output is in differential form, and is thus primarily targeted for applications such as driving twisted pair lines, or any application where common mode injection is likely to occur.该EL2141是一个非常高带宽差分放大器的输出形式，因而是主要的应用目标，如驾驶双绞线，或任何应用程序，其中共模注射可能发生。 The input signal can be in either single-ended or differential form, but the output is always in differential form.输入信号可在单端或差分形式，但产量总是在微分形式。

On the EL2141, two feedback inputs provide the user with the ability to set the device gain, (stable at minimum gain of two).在EL2141，两个反馈输入有能力提供设备的增益设置，（在两个最小增益稳定）的用户。

The output common mode level is set by the reference pin (V _REF ), which has a -3dB bandwidth of over 100MHz.输出共模电平是由参考引脚（V _号 ），它的- 3dB带宽为100MHz以上。 Generally, this pin is grounded, but it can be tied to any voltage reference.一般来说，这个引脚接地，但它可连接到任何电压参考。

The transmission of ADSL/HDSL signals requires very low distortion amplification, so this amplifier was designed with this as a primary goal. ADSL的/ HDSL的信号传输要求非常低失真放大，所以这是这个放大器设计为主要目标。 The actual signal distortion levels depend upon input and output signal amplitude, as well as the output load impedance.实际的信号失真水平取决于输入和输出信号的幅度，以及输出负载阻抗。 (See distortion data inside.) （见里面的数据失真。）

Both outputs (V _OUT , V _OUTB ) are short circuit protected to withstand temporary overload condition.两个输出_（V OUT的，五_OUTB）具有短路保护，以抵御暂时的超载情况。